![]() From there, motion.sh is called when pressing the button and stopped when pressing it again. To install, test and build on, copy/paste them into two files placed in the same directory, then run button.sh. I didn’t connect the breakout kit to the Raspberry Pi in software as I was unsure of how to represent a twenty-six pin ribbon cable, but the rest is there.Ĭurrently, the button turning on the motion detector, and the motion detector doing the logging runs the following scripts below. While viewing using Fritzing, you can see where positive and negative flow throughout the circuit, move wires around, add more parts, etc.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |